Pentax ME / ME Super Custom Kits

This page offers custom covering kits and light seal replacement kits for the Pentax ME and Pentax ME Super.

Note: The ME and ME Super are almost the same, but the rear door covering is different (the front two pieces are identical). Please make sure to choose your exact model when ordering.

All of our custom leather coverings are self-adhesive. When you apply them to your camera, you do not need any glue.

This is a custom replacement kit for the Pentax ME, ME Super, and MV-1 light seals (backdoor gasket sponge and mirror cushion).

These kits are ready-made. You don't have to do any cutting or measuring. All cuts are already made for you.

Note: 3 complete kits are included in one set, so you have spares in case you make a mistake.

Note: This kit only fits the Pentax ME, ME Super, and MV-1. It does not fit any other cameras.

This covering kit also fits the Pentax MV-1.

Installing the kit on your camera is very simple. We have provided 3 foam kits in one set so you don't have to worry if you waste one or two foam kits.

1. Remove the old light seals and clean up the residue from your camera with alcohol or benzine.
2. Take out the new light seal from the base paper.
3. Use a cotton swab or paint brush to rub alcohol or water on the adhesive (sticky) side. (The alcohol or water delays the adhesion and allows you time to position and adjust the seals.)
4. Place the seals into the narrow channels.
5. Use a flathead screwdriver to adjust the seals before the alcohol gets dry.